Acu-rite Micro-Line T Bedienungsanleitung PDF herunterladen (Seite 34)

MICRO-LINE Reference Manual

REFERENCE

The MICRO-LINE system is considered to be in the DRO (digital read-

out) mode when the X-axis and Z-axis positions are displayed.

DRO Mode

MICRO-LINE uses positive and negative numbers to display the position

of the tool along each axis. The graphic below shows a typical setup for

the positive and negative count directions for the X-and Z-axes on a

lathe. All of the examples in this manual are based upon this setup.

X-axis:

The axis will move away from the

center for a positive count direction.

Z-axis:

The axis will move away from the

spindle for a positive count direction.

Count Direction

Conventions

This section identifies the standard conventions that apply to your

MICRO-LINE system.

MLTmanual.QXD 2/12/02 4:10 PM Page 24

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 45 46

Keine Kommentare

Acu-rite Micro-Line T Bedienungsanleitung Seite 34